Skip to content

How to configure servos (Penny K Pinball PKONE)

Related Config File Sections:

You can drive up to four servos from each PKONE EX2 board.

Overview video about servos:

number:

When you're using PKONE EX2 boards, servos plug into individual EX2 boards. Then the boards are connected together in a chain to the controller.

image

The number: setting for each servo is its board's Address ID number in the PKONE chain, then the dash, then the servo output number (11-14).

servos:
  servo_1:
    number: 0-11    # EX2 with Address ID 0, servo 11 (the first one)
  some_other_servo:
    number: 2-14    # EX2 with Address ID 2, servo 14

Notes:

  • The PKONE EX2 board Address ID switches can be set from 0 to 7.
  • Servos are numbered from 11 to 14 on EX2 and not from 1 to 4.

All the servo config options are explained in-depth in the servos: section of the config file reference.

What if it did not work?

Have a look at our PKONE troubleshooting guide.

Something missing or wrong? You can fix it!

This website is edited by people like you! Is something wrong or missing? Is something out of date, or can you explain it better?

Please help us! You can fix it yourself and be an official "open source" contributor!

It's easy! See our Beginner's guide to editing the docs.

Page navigation via the keyboard: < >

You can navigate this site via the keyboard. There are two modes:

General navigation, when search is not focused:

  • F , S , / : open search dialog
  • P , , : go to previous page
  • N , . : go to next page

While using the search function:

  • Down , Up : select next / previous result
  • Esc , Tab : close search
  • Enter : go to highlighted page in the results